|
EZRip
Makes Drywall and
Plasterboard Scoring Easy!
|
|
The
EZRip makes scoring drywall and plasterboard
extremely simple, and gives you the most precise measurement possible
in the shortest amount of time. No more using your thumb as a
guide or snapping a very long chalk line; because EZRip
conveniently combines measuring, marking, and scoring into one
quick and easy operation with additional storage for 10 blades.
How
EZRip Works
With EZRip you either select the scale that corresponds to the
amount of wallboard you wish to cut (keep); or you select the
scale that corresponds to amount of wallboard that you wish to
leave.
|
|
|
Directions
Choose any one of EZRip’s measuring scales. Depress the locking
button and move the adjustable block to the selected setting.
Once the meausurement has been set, EZRip can be quickly drawn
across the wallboard panel for a clean, accurate cut. After the
scoring operation is complete, break the panel by hand, and cut
through the back of the paper with your utility knife. For best
results, always cut wallboard to fit loose.
|
|
|
“Use
EZRip instead of your t-square for cutting partial wallboard sheets”
While
the EZRip has been specifically engineered to make the long “rip”
cut of 48” (1200 mm) wide wallboard panels, it can also save
you time when cutting the length of partial wallboard sheets.
As illustrated below, use EZRip instead of your drywall t-square
for removing up to 24” (600 mm) of wallboard.
|
|
|
|
|
Metric
Model (millimeters)
|
USA
Model (inches)
|
|
USA
Model (imperial) - inches
The USA model of EZRip is engineered for super-fast horizontal
and vertical cutting of drywall panels. Choose from four
scales allowing you to cut 4’, 8’ and 12’
panels. Choose the 8’ scale to cut drywall between
72” to 96”; or choose the 12’ scale to
cut drywall between 120” to 144”. Need to make
a small rip? EZRip can make “rips” as small
as 2.375”. For best results when making very small
rips, score both sides of the drywall to ensure a clean
even break. Cut drywall less then your measurement between
1/8" to 1/4“.
Metric
Model - millimeters
The metric model of EZRip is engineered for super-fast
horizontal cutting of 1200 mm wide plasterboard panels.
Choose from two scales allowing you to cut plasterboard
as small as 60 mm. For best results when making very small
“rips”, score both sides of the plasterboard
to ensure a clean even break. Cut plasterboard less then
your measurement between 3 to 6 mm.
|
|
 |
|
